USB driver

Drivrutinen för stillbildsavbildning i kernelläge för USB-bussar har stöd för en enda kontrollslutpunkt, tillsammans med flera avbrotts-, mass-IN- och bulk-OUT-slutpunkter. The control and interrupt endpoints are accessible using I/O control codes and DeviceIoControl. The bulk endpoints are accessible using ReadFile and WriteFile.

Before calling DeviceIoControl, ReadFile, or WriteFile, you must call CreateFile (all described in the Microsoft Windows SDK documentation) to obtain a device handle. For devices that support no more than one of each endpoint type (control, interrupt, bulk IN, bulk OUT), a single call to CreateFile opens transfer pipes to each endpoint.

For devices that support multiple interrupt or bulk endpoints, a single call to CreateFile opens transfer pipes to the highest-numbered endpoint of each type. Om du vill använda en annan slutpunkt måste du göra följande:

1. Call DeviceIoControl, specifying an I/O control code of IOCTL_GET_PIPE_CONFIGURATION, to determine a port's endpoint index numbers (that is, indexes into the returned USBSCAN_PIPE_INFORMATION structure array). Note that these index numbers are not the endpoint numbers described in the Universal Serial Bus Specification.

2. Append a backslash and the endpoint's index number to the port name returned by IStiDeviceControl::GetMyDevicePortName when calling CreateFile.

Anta till exempel att en enhet (med portnamnet "usbscan0") har två slutpunkter av varje typ (avbrott, massinstans, massutdata) med indexnummer enligt följande:

If you call CreateFile with a port name of "usbscan0", the function opens transfer pipes to endpoints with index values of 2, 4, and 5, as well as the control endpoint.

If you call CreateFile with a port name of "usbscan0\1", the function opens transfer pipes to endpoints with index values of 1, 4, and 5, as well as the control endpoint.

For this device, if you want to use interrupt endpoint 0, bulk IN endpoint 1, and bulk OUT endpoint 3, call CreateFile three times, specifying port names of "usbscan0\0", "usbscan0\1", and "usbscan0\3". Detta skapar tre enhetshandtag. Whenever a subsequent call to DeviceIoControl, ReadFile, or WriteFile is made, the device handle associated with the desired pipe should be specified.

Because only one control endpoint is supported, specifying any I/O control code that uses the control pipe causes the driver to use the proper endpoint, regardless of which endpoint (if any) was specified to CreateFile.

Beskrivningar av alla I/O-kontrollkoder finns i I/O-kontrollkoder för USB Still Image.

USB-drivrutinen i kernelläge implementerar inte något paket- eller meddelandeprotokoll. Läsåtgärder kräver inte någon särskild paketjustering, men bättre prestanda kan uppnås om läsbegäranden justeras till maximala gränser för paketstorlek. The maximum packet size can be obtained using the IOCTL_GET_CHANNEL_ALIGN_RQST I/O control code.